Author Topic: home made ball cup tool  (Read 566 times)

Offline RedFordRob

  • Forum Veteran
  • ***
  • Posts: 224
home made ball cup tool
« on: November 25, 2016, 12:22:05 PM »
Found this on rctech it works great!
Here`s atool that will pop any ball cup without damaging it. Go to the hardware store and get a tack remover,used for pulling staples etc. It has a "v" grouve in it,I used a cut off wheel in an air grinder but a dremel tool will work also,round out the bottom of the grouve until it will just fit over the ballstud but not the cup. When you use it slip it under the cup and give it an upwards twist and off comes the cup. Total cost $3.00. 
LOSI TEN SCTE  2.0
LOSI 22SCT 2.0

Offline Bob

  • COR Executive
  • Mud caked
  • *
  • Posts: 1534
Re: home made ball cup tool
« Reply #1 on: November 25, 2016, 12:44:29 PM »
Great idea. My hobbyking  pliers scratch the crap out of the arms and cups when I use them. I'll have to try that. Think I have one of those lying around
TLR 22T, TLR 22SCT, AE B6
TLR 22SCT, Tekno SCT410
XRay 808, XRay XB4 2015,XRay XB4 2018
XRay XB2 2018, AYK Buffalo
STADIUM FOREVER!